King Ranch Color Dye Kit #1:(1) color - 8oz, (1) TC- 8oz, (1) SL7- 1/4oz, (1) sponge brush, (1) instructions

KIT INCLUDES:
1 - 8 oz TC Triclean Prep Cleaner
1 - 8 oz King Ranch Aniline Color (AN708, AN709 or AN710)
1 - 1/4 oz SL7 Super Link Crosslinker

1 - sponge brush

DESCRIPTION: A water-borne penetrating dye for coloring King Ranch aniline leather. Easily colors the front two seats. For the back seats, add another 8 oz. of color.

FEATURES: Easy to apply. Original look & feel.

PREP CLEANING:
Remove stains as much as possible. Spray a wet coat with (TC) Triclean Prep Cleaner over the entire area. Use a soft nylon brush to lightly scrub clean. Blot dry with a clean lint free towel or paper towel. Allow to dry completely. Use a hair dryer to speed up the drying process.
Check the leathers ability for penetration by placing a drop of water on several areas. Wait for minute, if the water leaves a dark circle, then the leather will accept aniline dye. If the water beads up with no dark circle, a second or third cleaning is required.
After the third cleaning and the water still beads up with no dark circle, lightly sand the leather with #600 sandpaper. This will help to break the surface coating and allow penetration. Clean again with #TC - triclean prep cleaner and a soft cloth or paper towel.

APPLICATION: Aniline leather finish (unprotected).

Colors: AN-708, AN-709, AN-710
1) Check color match. Mix crosslinker #SL-7 (1/4oz per 8oz of color) into the aniline dye color, helps to set the dye, (**ALWAYS ADD**). 

2) Apply a light coat of the aniline dye color by spray, wipe on or brush on method.
3) Allow to dry. A hair dryer may be used to speed drying.
4) Apply additional coats as needed, allowing each coat of color to dry to touch.
5) To slightly increase the gloss, apply a top coat clear of #AN - aniline clear mixed with crosslinker #SL-7 (1/4oz per 8oz of clear)

ADDITIVES: Always add #SL-7 super crosslinker. Makes the color permanent.

CLEANING: #TC - Triclean prep cleaner

TOPCOAT CLEAR: #AN - aniline clear (always add #SL-7 crosslinker)